What are the steps for using a glass edging machine?

     Glass edge machine is a kind of equipment used for glass processing, which is widely used in glass processing industry by grinding the glass edge, making the glass edge smoother, smoother and not easy to scratch. The correct use of glass edge grinding machine can not only ensure the processing effect, but also extend the service life of the machine. The following will detail the use of glass edge grinding machine and steps:

1. Pre-preparation

● Read the instruction manual: Before using the glass grinding machine, you should read the instruction manual in detail and master the transmission principle and maintenance knowledge of the machine.

● Check the power supply and gas source: make sure the power supply and gas source of the edge grinder is normal, turn on the power supply and open the gas switch.

Check all parts of the machine: check whether there is any abnormality in all parts of the edge grinder, if there is any abnormality, it should be reported for repair or replacement in time.

● Adjust the position of the grinding head: make sure the position of the grinding head and the moving clearance are correct, don't adjust them arbitrarily.

 

2.Start the edge grinder

● Turn on the air circuit: Turn on the air circuit and adjust the air pressure according to the operation procedure.

● Start the conveyor motor: Turn on the leakage switch and then start the conveyor motor.

● Adjust the feeding speed: Adjust the feeding speed according to the need, pay attention to prohibit adjustment when the conveying motor is off.

 

3. Place the glass

● Prepare grinding liquid and abrasive: Prepare the necessary grinding liquid and abrasive.

● Placing the glass plate: Place the glass plate to be processed on the table, making sure that it is in contact with the edge grinding wheel.

 

4. Edge grinding process

● Start edge grinding: Switch on the power switch, start the edge grinding machine and begin the edge grinding operation.

● Monitor the edge grinding situation: During the edge grinding process, you need to monitor the edge grinding situation to ensure the quality and safety of the edge grinding.

 

5. End work

● Turn off the water grinder switch: When the edge grinding is finished, turn off the water grinder switch.

● Stop machine operation: Stop the operation of the edge grinding machine.

 

 

6.Cleaning and Maintenance

● Clean the table: After finishing edge grinding, clean the residues on the table and the machine.

● Maintenance: Maintain the edge grinder regularly to ensure normal operation of the machine.

 

7.Precautions

● Observe the operating procedures: Work in strict accordance with the operating procedures and safety norms.

● Wear protective equipment: Wear appropriate safety protective equipment, such as gloves, glasses, etc., when operating.

● Avoid unauthorised adjustments: avoid adjusting machine settings without professional training.

 

     In general, when using the glass grinding machine, should ensure that the operator has sufficient knowledge and skills, follow the correct operating procedures, while focusing on safety measures to ensure that both the expected processing results, but also to ensure the safety of the operation process. Correct operation and regular maintenance is the key to ensure the long-term stable operation of the glass edge grinding machine.